Hello!

Did you know that logged in users can see a lot more content?

Design slabs, create and design patches, create and run punching shear checks

Added August 6, 2019 by Admin admin

Software version: 
Tekla Structural Designer 2019

Design slabs, create and design patches, create and run punching shear checks

Design slabs, create and design patches, create and run punching shear checks

Slab design in Tekla Structural Designer requires a certain amount of user interaction, (which is why slabs are not considered when any of the combined analysis and design commands are run).

Slab design can therefore be considered in isolation, the process being able to be broken down into the following discreet steps:

  1. Create slab patches over columns, beams, walls, or panels

  2. Design slabs (the slab areas that lie outside the patches)

  3. Design patches (the slab areas inside the patches)

  4. Create punching shear checks as required

  5. Design and check punching shear for the whole model or individually

Content rating: 
No votes yet